Thursday, December 3, 2009

big cloud weirdness of the day

Well this is high on my list of strange. 
I when I compile the code on the macMini to down load to the arduinio motors s,t and k start going down and don't stop ( until you pull the plug). When I down load the same code from my laptop it runs fine even when I change to talking to the board from the macMini. 


The mac mini will only run Ardunio 17 my latop is on 15. I'm down loading all the fixes to the mac mini in hope this sorts things out. 


Looks like motor 'O' is off line and naturally 'E' is to feeble. 


I still havn't run the cloud on full yet ( except accidently ) bit nervous about blowing the board. The network is now down so I'm a bit stuck. 

No comments: